Publicidad
Idiomas disponibles
Idiomas disponibles
5 Scope of delivery
The machine is also available with different acces-
sory parts. An overview can be found on page 4.
Subject to change.
A Nylon web compact disk
B File for profiling nylon web compact disks
C Sanding paper strips for file
D Microfibre cloth
E Stainless steel cleaning spray
6 Initial Operation
Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your power
supply.
6.1
Attaching the additional handle
Always work with the additional handle
attached (4)! Attach the additional handle on
the left or right of the machine and secure.
6.2
Attaching the hand guard
Always work with the hand guard (2)
attached.
Inserting:
- Press and hold the button (1).
- Slide the hand guard (2) into the slot from the
bottom to the top as shown (see illustration a,
page 3). First slide the glider with the widest
diameter approx. 5 mm into the external slot.
Then slide the glider with the smallest diameter
into the inner slot.
Note: Do not try to slide both gliders into both
slots at the same time, as this will not work. Start
with the external glider, and the inner glider will
follow automatically.
Turning:
- Press the button (1) and turn the hand guard until
the closed section is facing the operator.
- Make sure that the guard is securely positioned:
The button (1) must engage and you should not
be able to turn the safety guard.
7 Attaching the accessory
Disconnect the mains plug before changing
any accessories. The machine must be
switched off and the spindle at a standstill.
7.1
Positioning the accessory
See illustration b, page 3.
- The two sides of the support flange (9) are
different: Place the support flange (9) around the
spindle (10) in such a way that the large collar
diameter which corresponds to the accessory (8)
is facing upwards.
- Place the accessory (8) on the support flange (9).
The accessory must lay flat on the supporting
flange.
7.2
Tightening/loosening the clamping nut
Securing the clamping nut (7):
The 2 sides of the clamping nut (7) are different.
Screw the clamping nut onto the spindle (10) as
follows:
A
7
B
7
- A) In the case of thick (6 mm) accessories:
The collar of the clamping nut (7) faces down-
wards so that the clamping nut can be attached
securely to the spindle.
B) In the case of thin (3 mm) accessories:
The collar of the clamping nut (7) faces upwards
so that the thin accessory can be clamped
securely.
- Lock the spindle (10) using the Allen key (11).
Tighten the clamping nut (7) by turning it clock-
wise using the 2-hole spanner (12) (see illustra-
tion c, page 3).
Releasing the clamping nut:
- Lock the spindle using the Allen key (11).
Remove the clamping nut (7) by turning it anti-
clockwise using the 2-hole spanner (12) (see
illustration b, page 3).
8 Use
8.1
Setting speed
The speed can be preset via the setting wheel (5)
and is infinitely variable.
Positions 1-6 correspond approximately to the
following no-load speeds:
ENGLISH
ENG
9
Publicidad
