Descargar Imprimir esta página

[B] Draining Water Tank; Maintenance; Basic Cleaning - Hoshizaki DBF-AS65WE-EU Manual De Instrucciones

Dispensador automático de cerveza de barril

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 132
ENGLISH
2) Unplug the unit. The refrigeration unit and agitator motor stop.

[b] DRAINING WATER TANK

When shutting down the dispenser for more than a week, drain the water tank to prevent water contamination.
Note: It takes a few days after shutdown to melt ice in the water tank. Before
draining the water tank, shut down the unit in advance and check that ice
has melted in the water tank. Otherwise, it cannot be drained completely.
1) Remove the drain pan (accessory). See "III. 3. DRAIN PAN AND GRILLE
(DAILY)".
2) Place a bucket with a capacity of at least 35 L in front of the unit. Remove the
plug from the drain outlet to drain the water tank.
3) After draining the water tank, remove the top cover to dry the water tank
interior.
III. MAINTENANCE
Before carrying out any cleaning or maintenance operations, unplug the dispenser from the electrical supply network.
This appliance must not be cleaned by use of a water jet.
To prevent possible damage, do not clean the plastic parts with water above 40°C or in a dishwasher.
Use a neutral cleaner for daily maintenance and invert soap (benzalkonium chloride) for sanitization.
To prevent damage to the painted or plastic surfaces, do not use thinner, benzine, alcohol, petroleum, soap powder, polishing
powder, alkaline detergent, acid, scrub brush, and especially cleanser for use on fans and cooking ranges. Also, to prevent
corrosion, do not use a chlorine bleach (sodium hypochlorite).
When using chemical wipes, follow the manufacturer's instructions.
Use a clean cloth with clean hands.
More frequent cleaning may be required in some cases.
When using invert soap or sodium hypochlorite, thoroughly read and understand the instructions provided to prevent potential
health problems.
At the end of dispensing operation, clean the beer circuit every day to prevent contamination.
Clean your hands before handling or cleaning the parts.

1. BASIC CLEANING

1) Wash your hands.
2) Prepare clean cloths.
3) Unplug the unit.
4) Mix about 10 mL of 10% invert soap (benzalkonium chloride) solution in 1 L of warm water (30 to 40°C). Damp a dry cloth to
wipe the parts clean.
5) After 3 minutes, wipe off any remaining soap with a cloth containing cold or warm water. Then, wipe dry with a clean cloth.
HYGIENE
Tank Cover
Drain Pan
WARNING
NOTICE
HYGIENE
20
Drain Outlet
Bucket
Plug

Publicidad

loading