Symbols And Safety Warnings; Main Components; Assembly (Explanations On How To Remove The Packaging And Assemble Detached Parts) - EMAK Oleo-Mac MB 90 Manual De Instrucciones

more attention and caution, because the
perception of danger audio signals (screaming,
alarms, etc.) is limited.
Wear gloves offering superior vibration-
absorbing properties and protection against
contact with chemicals.
2. SYMBOLS AND SAFETY WARNINGS (Fig.19)
1. Danger due to the use of toxic substances in
mixture and liquid tanks
2. Read user manual
3. Must wear protective overall
4. Must wear ear protection
5. Must wear face mask
6. Must wear safety footwear
7. Must wear gloves
8. Do not release residual liquids in the
environment
9. Do not drink
10. Do not remove protection device while the
fan is working
11. Objects thrown by machine, keep safety
distance
12. This symbol indicates Warning and Caution
13. Poisonous substance
14. Serial number
15. CE conformity marking
16. Type of machine: MISTBLOWER
17. Year of manufacture
3. MAIN COMPONENTS (Fig.1)
1. Frame
2. Air filter
3. Spark plug
4. Starter handle
5. Engine cowling
6. Fuel tank
7. Harness
8. Cushion
9. Elbow tube
10. Flexible tube
11. Control handle
12. Blower tubes
13. Liquid cock
14. Diffusor
15. Wide spray jet
16. Chemical tank
17. Vibration mounts
18. Mixture preparation bottle
19. Combination wench
20. M5x65 screws (no.2)
21. M6 nuts (no.2)
22. 90 mm dia. hose clamps (no.2)
23. Liquid pipe
24. Bypass
4. ASSEMBLY
Assembling the tubes/handgrip
WARNING – When fitting the tube and
nozzle, the engine must be off and the switch
in the STOP position.
To assemble the mist blower read the following
instructions.
Machine components
Refer to Fig.3:
1. Insert the elbow tube into the fan casing.
2. Secure the elbow with the two screws and
two nuts supplied using the hex wrench
incorporated in the spark plug wrench
(supplied).
3. Refer to Fig. 2, fit the hose clamps on the two
ends of the flexible tube (10, Fig. 1), without
tightening them.
4. Fit the flexible tube onto the elbow tube
(9, Fig. 1) and onto the mist blower tube
(12, Fig. 1) taking care to ensure that the
cone (A, Fig. 2) is positioned towards the
mist blower tube; now tighten the two hose
clamps using the supplied wrench.
5. Raise the blocking lever (1, Fig. 5).
6. Insert the handle (11, Fig. 1) on the throwing
pipe (12).
7. When you have found the right position,
block the handle by lowering the block lever
(1, Fig. 5).
8. Insert the two liquid hoses (18, Fig. 1) D and
E on the handle (11, Fig. 1) as shown in the
GB
23