Black and Decker BCASCS60 Manual De Instrucciones página 13

tension as shown in Figure E. Make sure the saw chain
14 is snug around the guide bar
Fig. B
17
Fig. C
18
Fig. D
20
Adjusting Chain Tension (Fig. A, E )

CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is not running.

WARNING: Sharp moving chain. To prevent
accidental operation, ensure that battery is removed
from the tool before performing the following
operations. Failure to do this could result in serious
personal injury.
• With the saw on a flat, firm surface, check the saw chain
14 tension. The tension is correct when the chain snaps
back after being pulled 1/8" (3 mm) away from the
guide bar 13 with light force from the index finger and
thumb as shown in Figure I. There should be no "sag"
between the guide bar and the chain on the underside
as shown in Figure E.
• To adjust saw chain tension, loosen bar adjust locking
knob one full turn and follow instructions for
16
"Installing the Guide Bar and Saw Chain."
13 .
16
19
14
13
16
• Do not over-tension the chain as this will lead to
excessive wear and will reduce the life of the bar and
chain.
• Once chain tension is correct, securely tighten bar adjust
locking knob.
• When the chain is new, check the tension frequently
(after removing battery) during the first 2 hours of use as
a new chain stretches slightly.
Fig. E
1/8" (3 mm)
Replacing the Saw Chain (Fig. A, F)

CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is not running.

WARNING: Sharp moving chain. To prevent
accidental operation, ensure that battery is removed
from the tool before performing the following
operations. Failure to do this could result in serious
personal injury.
• Rotate the bar adjust locking knob
to release chain tension.
• Remove sprocket cover
the Guide Bar and Saw Chain" section.
• Lift the worn saw chain
guide bar 13 .
• Place the new chain in the slot of the guide bar, making
sure the saw teeth are facing the correct direction by
matching the arrow on the chain with the graphic on
the sprocket cover
17
• Follow instructions for "Installing the Guide Bar and Saw
Chain."
• Replacement chain and bar are available from your
nearest BLACK+DECKER service center.
• BCASCS60 requires replacement chain # RC1000, service
part number 90586161. Replacement 10" bar, service
part number 90586759 .
Fig. F
English
16 counterclockwise
as described in "Installing
17
14 out of the groove in the
shown in figure F.
11