Fig. K
Fig. L
7
Installing and Removing the Battery Pack
WARNING: Make certain the lock-off switch is
engaged to prevent switch actuation before removing
or installing battery.
nOTE: For best results, make sure your battery pack is
fully charged.
To install battery pack: Insert battery pack
housing
22
as shown in FIG. M until fully seated and an
audible click is heard.
Make sure battery pack is fully seated and fully latched into
position.
To remove battery pack: Depress the battery release
button
21
on the battery and pull battery pack out of
appliance.
Fig. M
20
3
2
20
into battery
21
22
OPERATION
WARNING: Read and understand all instructions.
Failure to follow all instructions listed below
may result in electric shock, fire and/or serious
personal injury.
•
Guard Against Kickback which can result in severe
injury or death. See Important Safety Instructions
guard Against Kickback, to avoid the risk
of kickback.
•
Do not overreach. Do not cut above chest height.
Make sure your footing is firm. Keep feet apart.
Divide your weight evenly on both feet.
•
Use a firm grip with your left hand on the bail
handle
and your right hand on the main
3
handle
so that your body is to the left of the
2
guide bar.
•
Do not hold chain saw by kickback guard
Keep elbow of left arm locked so that left arm is
straight to withstand a kickback.
WARNING: Never use a cross-handed grip (left
hand on the rear handle and right hand on the
front handle).
WARNING: Never allow any part of your body to be
in line with the guide bar
chain saw.
•
Never operate while in a tree, in any awkward
position or on a ladder or other unstable surface.
You may lose control of saw causing severe injury.
•
Keep the chain saw running at full speed the entire
time you are cutting.
•
Allow the chain to cut for you. Exert only light
pressure. Do not put pressure on chain saw at
end of cut.
WARNING: When not in use always have the
battery removed.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: Shock hazard. Under no circumstances
should this product be used near water.
WARNING: Burn hazard. Moving parts within the
base unit become hot during use. Avoid contact with
moving parts within base unit when removing and
installing accessories.
WARNING: Always use proper eye protection that
conforms to ANSI Z87.1 (CAN/CSA Z94.3) while
operating this appliance.
CAUTION: Wear a filter mask if the operation is
dusty. Use of gloves, long pants and substantial
footwear is recommended. Keep long hair and loose
clothing away from openings and moving parts.
English
11
.
13
when operating the
13