Location Of Controls; Power Supply - Roadstar TRA-1966 Manual De Instrucciones

WARNINGS
This unit operates on 230V ~ 50Hz. If the unit is not used for a long period
230v~
of time, remove the plug from the AC mains.
This unit must not be exposed to moisture or rain.
Ensure all connections are properly made before operating the unit.
This unit should be positioned so that it is properly ventilated. Avoid
placing it, for example, close to curtains, on the carpet or in a built-in
installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
Make sure all batteries are inserted according to the proper
polarity. Do not mix old batteries with new ones.
- +
If the unit is not used for a long period of time (more than 1 month),
- +
remove all batteries from their compartment to avoid possible leaking.
1
English
TRA-1966
3-BAND AC/DC Portable Radio.

LOCATION OF CONTROLS

1.
2.
3.
4.
5.
6.
7.
8.
9.

POWER SUPPLY

Battery Operation
•
•
•
•
AC Power Operation
•
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
2 English
ON/OFF/VOLUME Control
TUNING Control
Handle
HEADPHONE Jack
RADIO Dial Scale
BAND Selectors (MW/FM/LW)
Tone control (High/low)
Battery compartment
AC Socket
Open the Battery Compartment (8) at the back of the unit.
Insert first 6 x UM-2 batteries following the polarity diagram shown inside the battery
compartment.
Batteries should be removed from the compartment if the unit is not to be used for
some time.
Flat batteries should be removed from the unit to avoid leakage.
Connect the AC Power Cord to your AC household mains outlet and switch on the
mains supply. Make sure the voltage is compatible.