Oase AquaMaxEco Premium 2000 Instrucciones De Uso página 6

Ocultar thumbs Ver también para AquaMaxEco Premium 2000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

- English -
Installation
The unit can be placed submerged or dry.
Always place the unit below water level.
Place the unit horizontally on the ground ensuring its stable position.
Connect the unit
B
Recommendation for the use of the stepped hose adapter and hose connector:
• Second inlet (1): Stepped hose adapter 25 to 38 mm (1 to 1½ ")
• Pump outlet (2): Hose connector 50 mm (2 ") (alternative: stepped hose adapter 25 to 38 mm (1 to 1½ "))
Push the hose clip and the union nut over the hose. Fit the hose on the stepped hose adapter or hose connector and
secure with the hose clip.
Fit the stepped hose adapter or hose connector on the second inlet (1) or pump outlet (2) and hand-tighten the union
nut.
Operate the unit with the pond filter.
B
Connect the pump outlet (2) to the pond filter. Close the second inlet (1) with the screw cap.
Operate the unit with the satellite filter, or with the skimmer and pond filter.
C, D
Connect the second inlet (1) to the satellite filter or skimmer. Connect the pump outlet (2) to the pond filter.
Set the inlet regulator
G
Unlock the locking (9) (pull towards the inlet regulator) while pushing the inlet regulator (5) to the desired position (0 to
4).
• 0: Second inlet closed. Water is only drawn in via the housing (strainer casings).
• 1 to 3: Part of the water is drawn in via the housing (strainer casings), and part via the second inlet.
• 4: The second inlet is fully open. Water is only drawn in via the second inlet.
Recommendation:
• When operating with the second inlet closed, turn the inlet regulator (5) to 0.
• When operating with the satellite filter or skimmer, turn the inlet regulator (5) to a position between 1 to 4.
Install the unit at a dry place
E, F
Install the unit so that it is not exposed to direct sun radiation.
Open the clips (3) and remove the strainer top casing.
Release the clamp (4) and take pump out of the bottom strainer casing. Pull suction adapter (6) and inlet regulator (5)
from the pump.
Remove screws provided for fastening the holder (7). Remove holder from the bottom strainer casing.
Plug the rubber feet (8) (part of the accessory kit) in the openings provided for this purpose on the bottom of the hol-
der (7).
Place the pump back into the holder (7) and fasten with the clamp (4).
Connect the suction and pressure line. The require assembly items are included in the accessory kit.
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Aquamaxeco premium 3000Aquamaxeco premium 4000

Tabla de contenido