General Information - Daga MA-3500 Instrucciones De Uso

ENGLISH

GENERAL INFORMATION:

First check that the appliance is complete and undamaged. Contact
the store where you purchased the product in the event of any
doubt.
INSTRUCTIONS FOR USE
Prior to plugging in the product to the mains, check that your mains
voltage is the same as or is within the limits of the one indicated on
the product label. The safety instructions marked at the begin-
ning of this manual must be followed at all times when using this
product.
Follow the instructions that are presented below in order to start up
the appliance:
1. Remove the product from its original packaging taking special
care not to damage any of its parts. Do not use excessive force to
remove the product from the box.
2. Place the massage seat on an elevated chair or armchair in such
a way that the seatback is always in a vertical position and the seat
in a horizontal position. Ensure that the back of the seat or chair is
high enough to support the entire appliance. Attach the seatback to
the back of the seat using the retaining straps (3).
3. Connect the appliance to the mains.
4. Sit on the massage appliance, ensuring to sit upright so that your
back is fully leaning on the surface of the seatback. You must feel
comfortable at all times.
5. Turn on the device using the on/off button (16) located on the
appliance's control.
6. Set your preferences using the control to enjoy your massage
session and thermal comfort.
Session settings:
You should feel comfortable at all times while enjoying a massage
session and thermal comfort with the Daga MA-3500 seat. Gently
move your back around the surface of the seatback until you feel
more comfortable if the position you have adopted is not fully
comfortable. You can also try to reduce the pressure exerted with
your back on the seatback. If the unpleasant sensation continues,
stop the treatment and try it at another time.
• The recommended duration for each session is 15 minutes. After
that time, the massage appliance will automatically shut down to
prevent overloading the treated areas. If you wish to have an addi-
tional session, rest for around 15 minutes before starting again.
• When the device is turned on using key (16), all the operation
modes (full Shiatsu massage across the entire back, therapeutic
heat applied in the same area and seat vibration function) will be
automatically activated.
• You can configure the area of the back to be treated by pressing
the key (15). The appliance will be configured to massage the upper
area of the back only after pressing it for the first time. Pressing
the same key again will activate it to work on the lower area of the
13
Manual Asiento Masaje MA-3500.indb 13 13/1/16 12:17