Motor Connection - GAPOSA LP 250 Mono Manual De Referencia

- Once finished the emergency operation pull the green knob in order to disengage the chain device and give
power supply again to the system.
ATTENTION: make sure that the emergency device is unlocked so as to allow the electrical working of the
gearmotor when the black-out is over.
ATTENTION: The door, moved manually through one of the two above described procedures, should never
overcome the up or down limit switches. This is to avoid any damage to the door self and the intervention of the
safety micros, a safety device which cuts off the power supply and once activated, can be desactivated only by a
technician.

5. MOTOR CONNECTION

IMPORTANT SAFETY REGULATIONS to be respected:
1. SIDONE must be installed in compliance with all the electrical system and safety regulations in force.
2. A regular magnetothermic switch must be installed upline from the power supply circuit (16A onnipolar
device, minimum opening contacts = at least 3mm). The switch must be opened every time the gearmotor
and its control unit must be accessed.
3. The connection to the power mains must be performed by qualified technicians able to work in compliance
with the regulations. Check that the mains voltage supplied to the system corresponds to the voltage that
SIDONE requires. Also check that the line has an adequate cross section and is equipped with a ground wire.
If the above mentioned requirements are not respected, GAPOSA is not responsible and it is considered to be a
negligent use of the product.
6. ELECTROMECHANICAL CONTROL UNIT
The units for the control of SIDONE motors are many and suitable for this kind of powerful motors. The choice
depends on the degree of automation required: from the less expensive QC003, the intermediate QC03 till
QC03+, a multifunction control.
For single phase motors the available control units are: QC02, QC02 +.
LIMIT SWITCH BOX
9
8
7
6
5
4
3
2
1
YELLOW
Do not connect
GREEN
PINK
GREY
BLUE
Do not connect
BROWN
Do not connect
BLACK
RED
WHITE
Hollow shaft drive for rolling shutters
8
LIMIT SWITCH
normally closed
LIMIT SWITCH
normally closed
STOP
EMERGENCY
normally closed