Manual Override - GAPOSA LP 250 Mono Manual De Referencia

Hollow shaft drive for rolling shutters
3. INSTALLATION
SIDONE can be installed even in restricted spaces (fig. pg. 19). If despite the small size of the unit, the space
available is still insufficient, an optional chain drive kit is available to drive the rolling shutter with the gearmotor
installed remotely. Please consider the following min. space required for an easy installation and maintenance of
the motor:
- at least 350mm over the shaft end
- at least 450mm between the motor bracket and the roof
- at least 220mm between the middle of the shaft and the lintel
When fastening to the wall the bracket of the SIDONE to one side, and the bracket of the safety brake to the
other one, always allow for the difference in height to ensure that the rolling shaft is installed perfectly horizontal.
ATTENTION: The brackets must be fastened very carefully to the wall,keeping in mind both the stresses to which
they are subjected (these stresses are caused by the weight of the rolling shutter,the tube,the gearmotor, the
safety brake and by the torque that this weight, together with the friction, produces when the rolling shutter
runs). If this requirements is not respected, it could cause an extremely dangerous situation, and GAPOSA will not
be held responsible in any case.

4. MANUAL OVERRIDE

If a black-out occurs and You need to manually operate the shutter You should first check
which manual device is Your SIDONE equipped with:
- handle
- manual operation by chain (option)
and according to the device You have, proceed as follows:
ATTENTION! Before manually operate the shutter, disconnect the main power supply.This provision must be
followed even if the manual operation is equipped with an electrical safety. Remember to re-connect the power
supply after the emergency operation.
4.1 HANDLE (fig. 1a pag. 18)
To manually operate the shutter by means of the handle proceed as follows:
- insert the handle into the back of the motor and turn it till it gets the motor shaft;
N.B.: While introducing it, a safety micro will stop the power supply;
- turn the handle clockwise to open the shutter, anticlockwise to close it.
- once the manual operation is over, put the handle in its own place.
4.2 MANUAL OPERATION BY CHAIN (fig. 1b pag. 18)
To manually operate the shutter by means of the emergency operation by chain:
- pull the chain and simultaneously the red knob until the engagement of the emergency operation is done and
the safety micro has stopped the power supply.
- manually lift or lower the shutter by means of the chain.
ATTENTION: operate the chain in a regular way avoiding snatching
7