Connecting The Power Supply - Shizuoka Seiki VAL6 MPX Manual Del Usuario

CAUTION
■ Refueling
• Please use "kerosene" or "Fuel-Oil no heavier than No.2 (Diesel)" and do not use poor quality or foul fuel, to help avoid
ignition, operating, and other problems.
Remove the fuel cap and insert a handy
1
suction pump into the fuel tank.
Watch the fuel gauge while refueling.
2
When the gauge reaches the maximum
level, stop refueling.
■ Adjust the angle of the main unit
CAUTION
Prior to operation, loosen the knob bolt to
move and set the main heater unit at the
desired angle, and tighten the knob bolt
firmly.
The vertical angle of the radiation disk is
adjustable up to 45 degrees.

■ Connecting the power supply

Make sure that the operating switch is
1
"OFF", then plug the power plug into the AC
power outlet.
M a k e s u r e a g r o u n d e d p o w e r p i n o r
2
connection is used.
8
• Please refuel only while the heater is turned off and completely extinguished.
• Use only the electric power (voltage and frequency) specified on the model plate of the
heater to operate the heater. Using electrical power different from the specifications
may result in fire, electrical shock, and/or damage.
• Please confirm the ground/earth cable is properly connected, to prevent electrical shock.
• When disconnecting the electric power cord, be sure to always pull the plug out by it-
self. Do not pull out the plug by pulling on the power cord. Also, do not allow or cause
excessive force to be exerted on the cord at any time to avoid damaging it and causing
a fire or shock hazard. The heater should not be operated with the power cord in a taut
or tightened position to further avoid damage to the cord, accidental unplugging of the
electricity, and fire and/or shock.
Observations
• Do not adjust the angle of the main unit while the heater is plugged in, operating, or hot
to avoid severe burns and electric shock.
Wipe off any fuel that has spilled onto the
3
fuel tank or elsewhere.
Replace the fuel cap and tighten it securely.
Do not operate the heater with a loose fuel
cap or without a fuel cap.
Tighten
Loosen
AC Outlet
Power Plug
Connect
45 degrees