Publicidad
with reference to the following:
1. All electrical connections should be carried out by a suitably qualified
person(s)
2. All electrical connections should be in accordance with all applicable
National and Local Electrical Codes Of Practice.
3. It is the responsibility of the installer to include a suitable fuse / trip device
to isolate the appliance upon detection of an electrical surge or faliure.
OPERATION
Operation of Model CB-2002 (Fig.5)
ON /OFF & Power Selector Switch.
0
=
I
=
II
=
Thermostat Control Selector Switch
( )
=
*
(
) =
1. Turn the Thermostat Control Switch to the maximum position.
2. Select the desired heat output, 1000 or 1800W. Indication of power supply
and operation is provided by the illumination of the small neon light.
3. The first time the unit is switched ON, the surrounding environment will heat
up accordingly. When the desired temperature of the environment has been
reached, turn the Thermostat Selector Switch down until a "click" is heard.
The unit will switch OFF.
When the thermostat is in this position the appliance will automatically switch
ON and OFF to maintain this desired temperature.
Automatic anti-frost Device CB-2002
The CB-2002 wall mounted heater incorporates as standard an Anti-Frost
Protection Device which switches the unit ON automatically when the
temperature is less than +5
in use, simply turn the Power Selector switch to position (I) or (II) and then turn
the Thermostat to position ( ). Therefore when the temperature drops below
OFF
1000W
1800W
Frost Protector & Minimum Thermostat Position
Maximum Thermostat Position
0
C. To activate this device when the heater is not
*
11
Publicidad
