2.5 INSTALLATION AND START-UP
2.5.1 INSTALLATION
To continue with the assembly of the booth, follow the steps shown in the
following chart:
NOTE:
If the door is not assembled for reasons of transportation, or you want to
change the direction it opens in (Fig. 3), take the following steps:
•
To change the opening direction, turn the panel 180º.
•
To mount the door, place the hinges of the door facing the hinges of the
Panel
and insert the pins. Use a hammer to push the pins all the way
through.
•
Check the position of the closing wedge and reverse it if necessary.
•
Make sure that the door is adjusted and closes properly.
S-BASIC User's manual
Tools for assembly
501-800-MUM · Rev 2.03
EN 8