Assembly Guide - Sibelmed S-BASIC Manual Del Usuario

2.5.2 ASSEMBLY GUIDE

S-Basic Booth Assembly Guide
1
Panel (1)
Base
Place
A) the Base
(or wheels) against the floor
and as near as possible to its
final position.
Place the
B) Panel (1)
over the rubber of the Base,
taking into account the final
layout for the
Window Panel.
4
After this, place the
panel, and the corresponding
screws, but do not tighten them.
USER MANUAL
S-BASIC User's manual
2
Place
with its legs
centered on the rubber of
the Base. Make sure it is
aligned
corresponding screws, but
centered
do not tighten.
Door Panel and
Remaining
Panel (2)
the Panel (2)
and place the
5
Ceiling
Place the Ceiling on the booth (it will rest by its own weight,
son it is not attached by screws). If the room is not high
enough to allow this procedure, place the ceiling before
placing the last panel by sliding it over the sides (See
Figure 3).
The screws can now be tightened
ceiling) and the corner protectors placed over the corners.
8
3
Door Panel
Repeat the procedure with the
Door Panel or Window Panel
(depending on the final layout),
and place the corresponding
screws, but do not tighten
*
*
(side panels and
501-800-MU2_REV2.01
501-800-MUM · Rev 2.03
EN 9
.