Common Functions - RuarkAudio MRX Guia Del Usuario

Common functions

The CONTROL KNOB allows you to adjust the volume
and select source; however, for full control of the
network sources and access multi-room functions, you
will need the Ruark Link app.
For more details see www.ruarkaudio.com/link
Turn on and standby
To go to standby, press and hold the CONTROL KNOB
from any playing mode until the current source indicator
light turns off.
To turn on from standby, press the CONTROL KNOB.
Change volume
Rotate the CONTROL KNOB while listening to audio.
When you reach the maximum or minimum volume, the
source indicator light will briefly turn off.
EN-8
Connect to a new network
To connect your MRx to a different network (Wi-Fi or
Ethernet), press and hold the volume knob for approx.
4 seconds until all three source lights illuminate. Your
MRx will then reboot in SETUP mode and the front panel
lights will flash in sequence. You can now use the Ruark
Link app to connect your MRx to the new network.
See Setup section for more details.
Change source
Press the CONTROL KNOB to cycle through sources.
If your MRx is connected to Wi-Fi and you want to
connect it via Ethernet (or vice versa), you need to run
SETUP again.