NetSpa VITA Guia De Instalacion Y De Utilizacion página 29

12) Locate the place where the two
zippers are aligned, connect them and
start to zip the two parts together.
15) Insert the cartridge into its filter
holder and then screw on the suction
fitting inside the basin.
4.4. Pool cover and security
After each use, the control panel must be locked and the
pool must be coated with its top cover and it must be at-
tached to the base protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the
latch in up position locks the buckle, the latch in down posi-
tion unlocks the buckle.
The top cover keeps the heat from the water and secures the pool.
Warling : Do not leave spa unattended while filling with water.
Make sure the drain fitting is plugged securely and the cap is in place. Start filling the spa with water. After
about 1-inch of water is on the bottom, stop filling and smooth wrinkles out of the bottom of the spa. Pull
the outer wall out from the top edge, all around the bottom of the spa, so that it fills evently.
13) The two parts must be fully zipped
up.
16) Check that the drain plug is closed
properly.
Continue filling the spa until waterf level.
4. INSTALLATION
14) Connect the unit pump to the pool
using the 3 connectors to screw. Ensure
the icons on the pump and the pool
match up
17) Fill the spa pool until the indicated fill
level is reached.
Your spa is ready to be used.
EN