Instructions For Operation - Max PowerLite AKHL1260E Manual De Instrucciones

4. INSTRUCTIONS FOR OP-
ERATION
Unpack the compressor and check for any defi-
ciency, damage caused during transportation
and loose bolts and screws.
WARNING
READ SECTION TITLED " SAFETY INSTRUC-
TIONS "
WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the possi-
bility of dust being blown up by the exhausted air or
of a fastener flying up to the improper handling of
the tool. For these reasons, safety glasses or gog-
gles shall always be worn when operating the tool.
The employer and/or user must ensure that proper
eye protection is worn. Eye protection equipment
must conform to the requirements of Council Di-
rective 89/686/EEC of 21 DEC. 1989 (the Ameri-
can National Standards Institute. ANSI Z87.1) and
provide both frontal and side protection.
NOTE: Non-side shielded spectacles and face
shields alone do not provide adequate
protection.
NOTE: The information contained in this Instruc-
tion Manual is designed to assist you in
the safe operation and maintenance of
the compressor.
Some illustrations in this Instruction Manu-
al may show details or attachments that
differ from those on your own compressor.
1. GROUNDING INSTRUCTIONS
1. THIS PRODUCT MUST BE GROUNDED
In the event of an electrical short circuit,
grounding reduces the risk of electric shock
by providing an escape wire for the electric
current. This product is equipped with a cord
having a grounding wire with an appropriate
grounding plug. The plug must be plugged
into an outlet that is properly installed and
grounded in accordance with all local codes
and ordinances.
2. WARNING: IMPROPER INSTALLATION
OF THE GROUNDING PLUG IS ABLE TO
RESULT IN A RISK OF ELECTRIC SHOCK
When repair or replacement of the cord or
plug is required, do not connect the ground-
ing wire to either power terminal. The wire
with insulation having an outer surface that is
green with or without yellow stripes is the
grounding wire.
3. CHECK WITH A QUALIFIED ELECTRICIAN
OR SERVICEMAN WHEN THE GROUND-
ING INSTRUCTIONS ARE NOT COM-
PLETELY UNDERSTOOD, OR WHEN IN
DOUBT AS TO WHETHER THE PRODUCT
IS PROPERLY GROUNDED. DO NOT MOD-
IFY THE PLUG PROVIDED; IF IT DOES NOT
FIT THE OUTLET, HAVE THE PROPER
OUTLET INSTALLED BY A QUALIFIED
ELECTRICIAN.
4. CE MODEL IS FOR USE ON A NOMINAL
230-V CIRCUIT, AND USA MODEL IS FOR
USE ON A NOMINAL 120-V. EACH PROD-
UCT HAS GROUNDING PLUG. ONLY CON-
NECT THE PRODUCT TO AN OUTLET
HAVING THE SAME CONFIGURATION AS
THE PLUG. DO NOT USE AN ADAPTER
WITH THIS PRODUCT.
Grounding Pin
Grounded
Outlets
Plug
2. INSTALLATION
WARNING
1. NEVER USE THE MACHINE IN A PLACE
WHERE ANY VOLATILE COMBUSTIBLE
SUBSTANCE HAS BEEN STORED.
Never use it near gasoline, thinner, gas,
paint or adhesive agent, because they could
be ignited or blow up.
2. NEVER USE THE MACHINE NEAR THE
HEAT OF FIRE OR ANY COMBUSTIBLE
SUBSTANCE.
3. DO NOT USE THE MACHINE IN A OVERLY
DUSTY(WOODEN CHIPS, ETC.) PLACE.
13
Plug
Grounded
Outlets
Grounding Pin