Start Up; Adjusting The Cutting Depth; Cutting Angle Adjustment - Truper SICI-7-1/4N4 Manual De Instrucciones

The circular saw is a multipurpose tool to cut soft or hard wood, plywood, resopal covered materials, etc..
CAUTION
This tool is not designed to cut metal or masonry, cement or bricks.
Turning On
• Connect the plug in the power supply.
• Press the switch (A) so that the blade starts rotating.
• To stop the blade, release the switch.

Adjusting the Cutting Depth

1. Loosen the cutting depth blocking lever (B).
2. Having the base fixed, lift the housing until the blade is sticking out of the base to the desired depth. Use the depth
guide (C) as reference.
3. Tighten de cutting depth blocking lever to prevent the housing to move while cutting.
4. Cutting depth may de up to 60 mm
CAUTION • Cutting depth shall be equal to the work piece thickness or to protrude out of the piece one tooth of the
blade maximum to prevent accidents.

Cutting Angle Adjustment

• Loosen the cutting angle adjusting knobs (D).
• Fix the base and turn the housing until the blade is in the desired angle.
• Tighten the cutting angle adjustment knobs to prevent the housing to move while cutting.
• The tool can make cuts from 0° to 56°
D
8
ENGLISH
B
45°
Block

Start Up

A
Base
C