Craftsman 536.881651 Manual Del Operador página 23

[.,,."_o,,_ f_1 ZIB]P'_"_
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 22).
2. Remove the safety key.
3. Remove the mounting screws
(see Figure 23).
4. Slowly remove the snow hood.
Make sure that the primer button
hose and the ignition wire are not
disconnected.
5. The 8park plug can now be ac-
cessed.
6. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine
and secure with the mounting
screws (see Figure 23).
8. Connect the choke control knob
with the choke shaft on the carbure-
tor (see Figure 24 and Figure 25).
Make sure the choke control knob is
properly installed. If the choke con-
trol knob is not installed correctly,
the choke will not operate.
9. Install the 8afety key.
Choke
Contro
Snow Hood
Spark
Plug
Choke
Control Knob
Mounting Screws
Hose
gure 23
Figure 22
Choke Shaft
Figure 24
Safety Key
23
Carburetor
Figure 25