How To Assemble - Craftsman 536.881651 Manual Del Operador

NOTE: I fthecables h ave become dis-
connected, connect cables a sshown i n
Figure 7 .
Traction Drive C able Auger Drive C able
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage bolt. See
Figure 8.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector to flange Nut
with carriage bolt. Make sure to
install with head of carriage bolt on !
the inside of the flange. @_..
4. Fasten with waeher and Iocknut. I
5. Tighten Iocknut securely, Washer
NOTE: Make cure all carriage
bolte in flange are tight. DO NOT
OVERTIG HTEN.
Figure 7
Chute Deflector
Operating_
Position _
Carriage Bolt
Flange
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
10
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment section.