Num'axes Canicom 800 Manual De Instrucciones página 24

To select the dog you want to train on the remote control:
For CANICOM 800: Press the A or B key in order to select the collar (the letter A or B will appear on the
LCD screen).
For CANICOM 1500: Press the 1, 2, 3 or 4 key in order to select the collar (the number 1, 2, 3 or 4 will
appear on the LCD screen).
Button : beeper

If you press the « Beeper » button
function: the beeper will continue to sound for as long as the button is pressed.
It's up to you to use the beep key depending on the way you want to train your dog. With the beeper you
can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the beeper in the same way in order not to disturb your dog.
 "F" button: Flash stimulation
Press the « F » button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
 "C" button: Continuous stimulation
Press the « C » button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to 8
seconds maximum.
 "B" button : booster
Press the Booster button to stop your dog instantaneously.
You can choose the level of stimulation you think to be the best for an immediate effect. As a result, you
do not need to press the "+" button.
Those stimulations are transmitted by the two contact points located on the collar for as long as the
button is pressed but no more than 8 seconds max.
The level of stimulations selected thanks to the "Booster" button can be different for each collar.
Canicom 800-1500-Ind J.indd 24
Gb - 24
the collar will emit sound signals. There is no time limit for this
15/07/2019 11:40