Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points - Num'axes Canicom 800 Manual De Instrucciones

Ocultar thumbs Ver también para Canicom 800:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- Remove the old battery(ies).
- Insert the new battery(ies) paying attention to follow polarity indicated on the battery
housing.
- Put the battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
Replacing battery
of CANICOM 800
remote control
Diagram 9

Checking/replacing battery of receiver collar

To check the condition of the receiver collar battery, observe the On/Off indicator located on the front
of the receiver collar:
- Battery fully charged: flashes slowly green.
- Weak battery: flashes quickly red. Replace it with a new lithium 3 Volts CR2 battery (See § First
use from new: fitting the battery in the receiver collar).
Check the receiver collar operates correctly.

Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
Canicom 800-1500-Ind J.indd 26
Gb - 26
Replacing batteries
of CANICOM 1500
WARNING
Make sure the polarity is correct
remote control
Diagram 10
15/07/2019 11:40

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Canicom 1500

Tabla de contenido