Num'axes Canicom 800 Manual De Instrucciones página 29

- It is necessary to replace the battery every two years, even if the unit has not been used for long
periods.
- Never leave a discharged battery in the unit: leakage could damage your product.
- Remove the battery from the receiver collar and the remote control if you are not using the appliance
for 3 months or more. The collar will memorize the configuration chosen (coding).
Maintenance

- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the
receiver collar every year.
Troubleshooting

Should your CANICOM 800 / CANICOM 1500 stop working or develop a fault, first read this user's guide
over, then check the batteries and replace them if necessary and retry. Also check that you are using the
product correctly.
If you encounter any problem, re-code the receiver collar (ref. coding procedure).
Re-initialize the collar by removing the battery from its housing, then with a metallic tool (e.g. screwdriver,
scissors) touch each of the 2 battery contacts for approximately 2 seconds (ref. Diagram 11). Insert the
battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
Diagram 11
Reset: connect
the 2 supports of
the battery
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or by Email export@numaxes.com.
Depending on the extent of the malfunction, you may have to return your product for service and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs incurred.
Canicom 800-1500-Ind J.indd 29
Gb - 29
15/07/2019 11:40