Power Supply - babymoov Babyphone Expert Care Instrucciones De Uso

(A) Baby Unit
1. Operation from batteries
Press down the lock button and slide open the battery door in direction
as shown. Insert three pieces AAA size (UM-4) alkaline batteries into the
compartment. Observe correct polarities indication.
N.B. For best performance, do not mix use old and new batteries or
alkaline and rechargeable batteries.
2. Operation using AC adapter
The baby unit can be operated on AC mains using the supplied 5V AC
adapter. Connect the output plug of AC adapter to USB port (12) of the
baby unit, make sure the polarity is correct. The battery will be cut off
once the AC adapter's output plug is inserted into the USB port (12).
(B) Parent unit
1. Operation from battery pack
The Li polymer battery pack is already installed in the unit. To exchange battery pack, press and
open the battery cover, remove the belt clip in the direction as shown, take out the battery pack and
disconnect from socket.
2. Charging up the Lithium rechargable battery
Connect the output plug of the supplied 5V AC adapter to the USB port (22) of the unit, make sure
the polarity is correct. With the parent unit being switched off, the power on icon (18) will start flashing
red, indicating the battery is being charged. Once the battery is fully charged up (normally it takes
around 3 hours), the indicator (18) turns steady green. Now the parent unit can be switched on for
operation. Either you can disconnect the AC adaptor or keep connecting will cause no damage to
the battery. In the latter case, when the battery is being consumed and voltage falls to a certain
level, the AC adapter will automatically start charging up the battery again.
Note : Before using the parent unit for the first time, charge up the Li battery pack for at least
three hours. Besure to switch off the unit before charging. Even without the Li battery pack
being installed, the unit can still operate normally once connecting to the AC adapter, while
the power on icon will always stay steady green.
The baby and parent unit are already paired with factory preset code when they are shipped from
factory. However, we recommend to perform pairing again in case interference is experienced:
• First press and hold the button (15) of parent unit.
• Press the power ON-OFF button (13) and wait until the power on icon (18) starts flashing green.
Release both buttons (13) & (15).
• Now press and hold the button (11) of baby unit.
• Press the power ON-OFF button (1) and wait until the power on icon (7) starts flashing green. Release
both buttons (1) & (3) .
• Now short press the power ON-OFF button (1) of baby unit.
• If pairing is successful, the power on icons (18) & (7) on both baby & parent unit should stop flashing,
at the same time, 2 beep sound will be heard from the parent unit.
• Long press buttons (1) & (13) to switch off both baby and parent units and then switch them on
again, the baby monitor is now ready for operation.
• In case the baby and parent unit cannot communicate with each other, repeat steps 1 - 7 again
10

POWER SUPPLY

PAIRING
BABYPHONE EXPERT CARE • Instruction manual
12