Safety
2
Safety
WARNING!
Observe all safety instructions!
Please also always note all safety instructions from the main operating
manual of the Versatronic (article no. 417102269)!
2.1
General safety advice
DANGER!
If you believe that the unit can no longer be operated safely, you must
decommission it immediately and secure it so that it cannot be used
inadvertently.
This applies:
– if the unit shown visible signs of damage;
– if the unit no longer appears to be operational,
– after prolonged periods of storage under unfavourable conditions
(perform functional check).
The following regulations must always be observed when handling
the system:
– Before any work takes place on electrical parts, the system must be
disconnected from the power supply and protected against being
switched back on.
– Safety regulations and prescribed protective clothing when handling
chemicals should be followed.
– Attention must be paid to the information included on the product data
sheet for the metering medium used.
– The system must only be operated with the supply and control voltage
specified in the Technical Data section.
2.2
Workforce requirements
It is absolutely essential that you consult the list of responsible personnel
and the respective required skills in the main instructions 417102269,
chapter 2.
2.3
Personal protection equipment (PPE)
DANGER!
Personal protective equipment, or PPE, is used to protect personnel.
The PPE described on the product data sheet (safety data sheet) of the
liquid to be measured must be used.
417102279 Rev. 2-08.2020
8