Hoshizaki FM-170EE-HC Manual De Instrucciones página 4

* Wash your hands before removing ice. Use
the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not
store anything else in the bin.
* Clean the storage bin before use (see "III. 1.
CLEANING").
* Keep the scoop clean. Clean it by using a
neutral cleaner and rinse thoroughly.
* Close the door after removing ice to
prevent entrance of dirt, dust or insects into
the storage bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
* Do not damage the power cord or pull it in
order to disconnect the icemaker from the
feed network.
* Use the attachment plug as the main
power disconnect switch for the icemaker.
* Appliance must be positioned so that the
plug is accessible.
* Do not touch the attachment plug and other
electrical parts or operate the Operation
Switch with damp hands.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
* Do not attempt to modify the icemaker.
Only qualified personnel may disassemble
or repair the appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. OPERATION
The installer will normally commission the icemaker
to start the automatic icemaking process. To ensure
continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is plugged into the power supply.
2. PREPARING THE ICEMAKER FOR LONG
STORAGE
1) Run the icemaker with the water supply tap
closed.
2) Make sure the icemaking process has been
completed. Remove the inlet hose from the water
tap, and drain the hose.
3) Unplug the icemaker.
4) Remove all ice from the storage bin, and clean the
bin.
5) Ask for draining of the icemaker by professional
qualified personnel.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
m a i n t e n a n c e o p e r a t i o n s , u n p l u g t h e
icemaker from the electrical supply network.
2. Ask a trained service person to clean the
condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
[1] Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
[2] Storage Bin Interior Cleaning/Sanitisation
(as required)
1) Open the storage bin door, and remove all ice.
2) Remove the drain cap located in the base of the
storage bin.
3
ENGLISH