Safety Information - Powerfix Profi+ 102875 Instrucciones De Servicio Y Seguridad

The equipment is to be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not been designed for use in com-
mercial, trade or industrial applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial businesses or for
equivalent purposes.

5. Safety information

1 The rated load limit must not be exceeded, as overload can damage
the chain hoist or reduce the lifting capacity in the future.
2 Do not use electrical appliances to operate the chain hoist. The chain
hoist is designed for manual use only.
3 Do not try to repair the load chain. If it is damaged, the load chain
should only be replaced by an expert. The load chain must be replaced
with a new one of the same welded and hardened steel, in the same
size and strength/thickness.
4
The load chain should be greased before use.
5 The brake surfaces must not be greased. The brake must be kept dry
6 Make sure that the load chain has no knots. If there are knots in the
load chain, these must be removed before use.
7 Make sure the load chain is hung on the chain pulley before each use.
8
When pulling the hand chain, stand in the same position and angle
as the drive wheel. Do not pull at an oblique angle. A secure posture
is necessary.
9 Do not lift the load so that it is above any persons. Do not allow any
persons to walk underneath the load. If you wish to lift a load, please
warn anyone in the surrounding area.
10 Do not lift any persons with the chain hoist.
11 The load must be held firmly in the hook. Try not to lift the load with
the point of the load hook.
12 Pull the hand chain evenly, to avoid thrusts or entanglements.
13 If the chain is barred or cannot be pulled further, please stop. Exam-
ine and resolve the problem. Do not attempt to use force on the chain
hoist. Do not leave the load hanging in the air.
14 Please do not lower the load further than the usable length of the
chain. If the chain between the chain wheel and the chain pulley is
pulled too taught, this can cause damage.
15 Do not allow the load to come into contact with the chain hoist, other-
wise free rotation will be blocked, which could cause damage, knots
in the chain or barred wheels.
16 Regular checks and maintenance should be carried out. All damaged
or faulty parts must be exchanged by an expert.
17 The chain hoist functioning in both "with load" as well as "without load"
40 GB