Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the handlebar (12) to the Right
top frame (15), using Bolt (37) with
washer (43) and Bolt (39) with washer
(44). Insert the Plug (28) into the end,
as shown in Fig.3.
Then, Assemble the Left handlebar
(11) using the same method.
5.- FITTING THE WOOD BALL.-
Attach the Speed ball base (47) to the
Wood for ball (18) using Bolts (42).
Attach the wood (18) to the wood base
(9) using Bolts (37) and Washers (43).
Insert the Plug (27) and the Sleeve
(26) into the wood base (9). Fig.3
Screw the Pop-Pin (30) to the wood
base (9). Do not tighten it for the
while.
6.- FITTING THE ARMREST
SUPPORTS.-
Insert the Right top frame (15) through
the wood base (9) and then insert it
into the Upright (4).
Insert the Left Top Frame (5) into the
other Upright (4).
Attach the part (7) and (6) to the
Upright and Right top frame (4) and
(15) using Hex Bolts (35) and washers
(43).
Attach the Backrest frame and Right
arm frame (7) and (48) to the Upright
and Left Top Frame (4) (5) using Bolts
(35) and washers (43).
Set the End Cap (32) to the Left arm
frame and Right arm frame (6) and
(48), and then set the Comfort Grip
(22) onto the Left arm frame and Right
arm frame (6) and (48). Fig.4
7.- FITTING THE BACKREST &
ARMRESTS.-
Attach the Backrest pad (21) to the
Backrest Frame (7), using Hex Bolt
(40) with washer (44).
Separately attach the two Arm pads
(20) to the Left arm frame (6) and the
right arm frame (48), using Bolts (38)
with washers (44).
Then Attach the Foot Tube (14) to the
Connecting frame (3) using Bolt (36)
with washer (43) and nut (45). Insert
the Plug (29) into the Foot Tube (14).
Slide the Foam Roller (25) onto the
Foot Tube (14).Fig.5
8.- ATTACHING THE BOXING
FRAMES .-
Insert the Plug (27) into the Top cable
tube (10). Attach the Top cable tube
(10) to the Left top frame (5) using
Bolt (34) with Washer 43 and Nut (45).
Insert the Plug (28) into the Sand bag
upright (13). Attach the Sand bag
upright (13) to the Backrest frame (7)
using the Back plate (19) and Bolt (35)
with Washer (43). Fig.6.
Hook the Boxing Heavy Bag (49) on to
the Rear Support Tube (13) using one
Snap Hook. Fig.7.
Hook the Floor to Ceiling Ball (50) on
to the Left Bend Tube (10) and Left
Bottom Tube (16) using two Snap
Hooks (51). Fig.8
Install the Speed Ball (46) on to the
Speed Ball Hanger (47). Remove the
C Clip and Plate from the Speed Ball
Hanger (47) by using a pliers. Fig.9.
Wrench tighten all the bolts and nuts.
Turn the Spring Knob in a counter
clockwise direction until it can be
pulled out. Pull out the Spring Knob
and then slide the Speed Ball Support
Tube up or down direction to the
suitable position.
12
Publicidad
