Fitting Instructions; Dynamic Alignment - Blatchford AqualimbTF AQTF22L Instrucciones De Uso

8 Fitting Instructions

1
Fit shin to housing ensuring full
engagement. Measure length
to determine amount to be cut
from shin.
Determine final cut length
required. Remove shin from
housing, cut to length and
reassemble then check
measurement.
45 mm
2
1
4
Tighten clamp screws evenly, applying a torque
of 5 Nm at least twice to each screw. Example
order of tightening shown to evenly spread load.

9 Dynamic Alignment

Set up as shown in Bench Alignment if the user requires adjustment length, shift,
rotation and angular adjustments are available by loosening, adjusting and re-
tightening of distal and proximal alignment fixings.
Ensure after any adjustments are made, that the load line is not posterior to the top
pivot pin.
3
2
3
Check length and alignment.
Finalise the screw settings
during dynamic alignment.
7
938321/4-0819