Tabla De Contenido; Safety - 3M ESPE Visio Beta vario Instrucciones De Servicio

SEITE 1 - 148 x 210 mm - 086/0/-/51+ F -
ENGLISH
Visio ™ Beta vario
Light Unit for 3M ESPE Sinfony
Polymerization
Table of Contents
1. Safety
2. Product Description
3. Technical Data
4. Start-up
5. Operation
6. Malfunction
7. Maintenance
8. Care
9. Storage / transport
10. Customer Information
SCHWARZ - 03-0132 (sr)

1. Safety

PLEASE NOTE!
Prior to installation and start-up of this unit, carefully
read the instructions provided herein! As with all technical
™
devices, the proper function and safe operation of this unit
depend on the user's compliance with the standard safety
procedures as well as the specific safety recommendations
provided in these Operating Instructions.
1. The unit must be operated in strict accordance with the
following instructions. The manufacturer accepts no
liability for any damage resulting from the use of this
unit for any purpose other than specified.
2. Prior to start-up of the unit make sure that the operating
voltage stated on the rating plate is compatible with
the available power supply. Operation of the unit at a
different voltage may damage the unit.
3. Condensation resulting from the unit being transferred
from a cold to a warm environment may be a potential
hazard. Hence, the unit should be turned on only after it
is completely equilibrated to ambient temperature.
4. Operate the device only with an appropriately rated
power outlet with protective conductor. If you use an
extension cord, please make sure that the protective
conductor is not interrupted.
5. Prior to any change of lamps, the unit must be turned
off and disconnected from the power supply.
6. In order to avoid electrical shock do not introduce any
objects into the unit with the exception of replacement
parts handled in accordance with the Operating
Instructions.
7. Replace defective parts exclusively with original
3M ESPE replacement parts in strict compliance with
the Operating Instructions. The product guarantee
does not cover any damage resulting from the use of
third-party replacement parts.
8. Should you have any reason to suspect the safety of
the unit to be compromised, the unit must be taken out
of operation and labeled accordingly to prevent third
parties from inadvertently using this possibly defective
Page
unit.
1
The safety may be compromised, e.g. if the unit
malfunctions or is visibly damaged.
2
9. Solvents, flammable liquids, and powerful heat sources
2
must not be kept in the vicinity of the unit as either of
these factors may damage the plastic housing of the
2
unit.
2
10. Do not allow cleaning agents to enter the unit as
this may short-circuit the unit or cause potentially
3
dangerous malfunction.
3
11. Only factory-authorized technicians are authorized to
open the housing of the unit and carry out any repairs.
4
12. It is not permissible
4
- to cover the unit with a glass plate instead of the
4 designated lid (may lead to bursting since there is no
illumination from above),
1