Publicidad
Idiomas disponibles
Idiomas disponibles
8392_SPOILER_5 DVERI_OCT II.fm Page 8 Thursday, December 16, 2004 1:31 PM
- 3 -
- Rough the bottom surface of the spoiler (A) determined for gluing with emery paper
carefully, and clean it with agent HHA 381 011 (the whole surface including the groove
along the whole circumference of the spoiler).
Caution! The gluing surface must be completely free of grease, remains of var-
nish and basic coating!
- 4 -
- Cut off the nozzle of the tube with gluing cement (B) according to the picture, and
apply the gluing cement in the shape of a continuous "bead" on the whole circumfe-
rence of the seating surface of the spoiler (A). Moreover, apply a wave-shaped "bead"
of gluing cement in the zone of the bending radius. The size of the "bead" is to be 6
mm approximately.
- 5 -
th
- Set up the prepared spoiler upon the 5
door, symmetrically to the axis of the vehicle
according to the picture.
Caution - if some glue gets pressed out around the glued part, clean it with the
cleaner HHA 381 011 immediately.
- 6, 7 -
- Fix the glued spoiler in several places with bodywork sealing tape -arrows-, in parti-
cular in its lateral zones (to increase the pressing force, the tapes can be glued across
plastic foam blocks -detail-.)
- Moisten the surrounding of the glued spoiler with an atomiser, in order to provide for
faster cross-linking of cement in the interstice between the spoiler and the lid of lug-
gage compartment.
- Cover the spoiler with PE film -arrows- (not included in the supplied set) and glue it
with a suitable sealing tape to the bodywork of the vehicle. In this way, a micro-climate
with increased humidity is obtained, suitable for faster cross-linking.
With the spoiler glued in this way, the vehicle must be left at rest for 24 hours.
The glue must reticulate properly. After 24 hours, remove sealing tapes and
check the gluing of the spoiler visually.
- 8 -
Draw customer's attention to the following instructions:
- within 48 hours after gluing, drive at the speed of 100km/h at most,
- within 72 hours after gluing, do not go with the vehicle to a car wash.
These rules must be respected in order to provide for quality gluing of the
th
spoiler of the 5
door.
Black process 45.0° 141.0 LPI
Publicidad
