Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 BEFORE USING THE OVEN FOR THE
FIRST TIME
PRELIMINARY CLEANING
Clean the oven before using for the first time:
•Wipe over external surface with a damp soft cloth.
•Wash all accessories and wipe inside the oven with a solution of hot
water and washing up liquid.
•Set the empty oven to the maximum temperature and leave on for
about 1 hour, this will remove any lingering smells of newness. Ensure
that the room is well ventilated while this is being done.
THINGS TO REMEMBER
Confirmation of operation on timer:
•Modification must be confirmed by pressing "
Stop the oven:
•This may be necessary if you have input an incorrect instruction. To
START
stop the oven, press the "
STOP
CLOCK SETTING
When the oven is connected to the electricity supply for the first time of
after a long power cut, the clock must be re-set.
To set the clock:
1.Press the "
" for few seconds and find the "
then press the "
". The digits on the central display will blink.
2.Set the clock by using
"
" again to apply your setting.
ADJUSTING THE DISPLAY CONTRAST
1. Press the "
" for few seconds and find the "
then press the "
". (The contrast of the display brightness is
included between "1" maximum and "5" minimum.)
2. Choose the contrast level by using
press the "
" again to apply your setting.
NOTE: If you want to set the clock or to adjust the display contrast after
the first switching on of the oven, press the "
oven, and proceed how described in the points 1 and 2 of the specific
paragraphs.
MINUTE MIND
ON
OFF
1.Press the "
" for switch on the oven.
2.Press the "
" for few seconds and find the "
then press the "
" .
3.Set the required time by using the
press the "Temperature/Time SET
NOTE: This function allows oven to be used as an alarm clock
independently form the working oven.
CHILD LOCK
1. To set the child lock press "
2.
To activate press "
" "OK"
To activate press "
" "NO"
NOTE: It is possible to activate child lock both when the oven in ON
and OFF
" .
" .
" by using
then wait a few second or press the
"by using
then wait few seconds or
ON
OFF
" for switch on the
"by using the
, then wait a few seconds or
" again to apply your setting.
" for few seconds.
5.2 HOW TO USE OVEN
SINGLE MODE
To use the Single Mode, remove the seperator from the oven.
You can choose all the functions below with Single Mode.
The cooking methods suggested are set out in the table below. A
temperature is also suggested for each cooking method. This can be
modified within a pre-determined range.
Function Mode according
to the oven model
Off
Bottom
Bottom+Fans
Bottom+Top
Bottom+Top+Fans
Circular Heating Element
+Fans
Grill
Grill+Fans
Grill+Turnspit+Fans
,
Defrost
Keep Warm
Pyro * * *
,
*Booster: rapid temperature raised
ON
OFF
1.Press the "
" to switch on the oven.
2.Press the "
". Choose function required to the cooking by using
.
3.The appropriate temperature or level cooking, according to the
cooking method selected is displayed. It can be modified within a pre-
determined range - see table above. To modify the temperature
setting, press the "
Then press the "
fixed but can be modified during the cooking cycle.
4.To start the cooking, press the "
cooking and will start to heat up. The indicator light blinks until the
selection temperature has been reached. An audible sounds at the the
,
end of this operation and the indicator light becomes fixed.
5.To change the oven function, repeat the steps for 2 to 4.
6.To stop the cooking press the "
DUAL MODE
To activate the Dual Mode, put the separator into the third position
shelf of the oven. You can choose the functions below with Dual Mode.
ON
1- Press the "
" switch on the oven.
OFF
2- Press the "
" select which part of the oven cavity (UPPER or
LOWER) must be used; choose the function required to the cooking
by using the
.
3- The appropriate temperature or level cooking, according to the
method selected is displayed.
It can be modified within a pre-determined range-see table below.
To modify the temperature setting, press the "
temperature by using
Then press the "
"again to confirm. The temperature display is fixed
but can be modified during the cooking cycle.
4- To start the cooking, press the "
The oven will start cooking and will start to heat up. The indicator light
blinks until the selected temperature has been reached; an audible
sounds at the end of this operation and the indicator light becomes
fixed.
5- To stop the cooking, select the "
06 GB
Pre-set
Pre-determined
temperature
temperature °C
°C
-
-
160
50-240
210
50-240
220
50-280
210
50-240
180
50-240
L2
L1-L3
210
180-230
240
180-240
40
No
60
No
ECO:425/65min
NORMAL
NORMAL:425/75min
SUP:425/1h30min
" and choose the temperature by using
" again to confirm. The temperature display is
START/STOP
" . The oven will start
START
".
STOP
.
START/STOP
" .
".
Function
Booster*
-
-
Booster
-
-
-
-
Booster
Booster
-
-
-
.
" and choose the
Publicidad
Tabla de contenido
