Horizon Fitness T100 Manual Del Propietário página 5

ASSEMBLY STEP 3
HARDWARE BAG 3 CONTENTS :
BOLT (B) SPRING WASHER (C) FLAT WASHER (D)
15 mm 15 mm 15 mm
Qty: 6 Qty: 4 Qty: 4
CONSOLE CABLE
(THREAD THROUGH HOLE
IN RIGHT HAND GRIP)
HAND GRIP
CONSOLE MAST
ARC WASHERS (F)
BOLTS (B)
8
T100-OM-rev1.2.indd 8-9
Open hardware bag 3.
A
Insert left hand grip onto upright
B
console mast.
ARC WASHER (F)
18 mm
Qty: 2
Attach the left hand grip to the console
C
mast using 2 bolts (b), 2 spring
washers (c) and 2 flat washers (d)
from the inside and 1 bolt (b) and 1 arc
washer (f) from the front.
Carefully thread the console cable through
D
the hole in the right hand grip.
Attach the right hand grip as explained
E
above in steps b–c.
NOTE: Do not completely tighten any
step 4
screws or bolts until is complete!
NOTE: Be careful not to pinch any wires
FLAT WASHERS (D)
while assembling the masts.
SPRING WASHERS (C)
BOLTS (B)
ASSEMBLY STEP 4
CONSOLE
HAND GRIP POST
ARC WASHERS (H)
SCREWS (G)
CONSOLE
CONSOLE CABLE
UPRIGHT MAST
CONSOLE CABLE
COVER
HARDWARE BAG 4 CONTENTS :
SCREW (G) ARC WASHER (H)
10 mm 12 mm
Qty: 4 Qty: 4
Open hardware bag 4.
A
Slide the console onto the hand grip posts.
B
Attach the hand grip posts to the console
C
using 4 screws (g) and 4 arc washers (h)
from the below the console.
NOTE: Be careful not to pinch any wires
while attaching the console.
Connect the console cables and carefully tuck
D
wires in mast to avoid damage. Note: do not pinch
console cable. Be sure the console cable prongs
are aligned and the ends are tightly seated into each
other.
Attach console cable cover.
E
go back and completely tighten all bolts and screws
F
from steps 1-4.
9
7/28/10 9:02 AM