Publicidad
Idiomas disponibles
Idiomas disponibles
12
MicroLogix™ 1200 Programmable Controllers
Dimension
A
B
C
To install your controller on the DIN rail:
1. Mount your DIN rail. (Make sure that the placement of the controller on the
DIN rail meets the recommended spacing requirements, see Controller
Spacing on page 11. Refer to the mounting template inside the back cover of
this document.)
2. Close the DIN latch, if it is open.
3. Hook the top slot over the DIN rail.
4. While pressing the controller down against the top of the rail, snap the
bottom of the controller into position.
5. Leave the protective debris strip attached until you are finished wiring the
controller and any other devices.
To remove your controller from the DIN rail:
1. Place a flat-blade screwdriver in the DIN rail latch at the bottom of the
controller.
2. Holding the controller, pry downward on the latch until the latch locks in
the open position.
3. Repeat steps 1 and 2 for the second DIN rail latch.
4. Unhook the top of the DIN rail slot from the rail.
open
Publication 1762-IN006D-MU-P - March 2004
Height
90 mm (3.5 in.)
27.5 mm (1.08 in.)
27.5 mm (1.08 in.)
closed
Publicidad
