Connecting The Main Connector - Eneo VHM-Z Serie Instrucciones De Manejo

4. Connecting the main connector

Z The housing is equipped with a main connector Z. The incoming mains power supply/video and control
cables are connected to it; the configuration is shown in the table opposite. (Premounted at
VHM-ZLKCB-W)
Note
The minimum specification of the mains power supply cable to the power supply circuit must conform
to Type H05xx, wire end ferrules must be used on flexible thin strand connecting cables. The PE earth
wire terminal must be pre-mated, care must be taken to connect L and N correctly. The video and
control cables must be fastened to ensure that they cannot come into contact with any parts of the
primary circuit.
a0 30VAC
a9 -
a8 +5V (external power supply)
Z
a7 Long focal distance
a6 Pan/Tilt 0V
a5 Close range
a4 +V reference
a3 -V reference
a Zoom pot wiper
a Focus pot wiper
b0 Ground (GND)
b9 -
b8 Pan/Tilt low
b7 Pan/Tilt high
b6 Short focal distance
7
b5 Long range
b4 -
b3 Video ground
b Video output
b -
c0 30VAC
c9 -
c8 Pan/Tilt right
c7 Pan/Tilt left
c6 Heater (/4V)
c5 Heater (/4V)
c4 -
c3 Synchronous input
c Ground
c -