Descargar Imprimir esta página

Olymp LavaSit DINER Shiatsu Instrucciones De Montaje página 7

Ocultar thumbs Ver también para LavaSit DINER Shiatsu:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
Mounting instructions for electricians:
The safety regulations of the hairdressing trade must
be observed. Installation and operation must be in
accordance with the norm DIN VDE 0100.
During assembly work the complete system
must be isolated from the power supply and
secured against unintended switch-on!
In the wash unit, use only the plug-in connectors
supplied with the appliance and specified in the
mounting instructions!
Cables must be so arranged that they are not in the
vicinity or moving parts! Damage or crushing must
thus be prevented!
The power supply cable from the unit must be
arranged so that it is not jammed between the
unit frame and the floor.
The mains cable must be led outward completely and
provided with strain relief.
For reasons of mechanical security as well as the
electromagnetic compatibility no cable excess may be
stowed away in the shampoo unit.
Variants for single units:
13.1
Direct wiring variant: (fig. 5)
Caution: This type of connection must only be
made by a qualified electrician!
- Connect the mains cable from the floor to the
supplied system socket (fig. 3).
- Insert the socket into the system connector
underneath the cover section and fasten the locking
clip (fig. 4).
13.2
Mains cable variant: (fig. 6)
Lead the mains cable with plug outside under seat.
In-line installation variants:
13.3
In-line unit with direct connection (fig. 7)
Caution: This type of connection must only be
made by a qualified electrician!
- Connect the mains cable from the floor to the
supplied system socket (fig. 3).
- Insert the socket into the system connector
underneath the cover section and fasten the locking
clip (fig. 4).
13.3
In-line unit with mains cable (fig. 8)
Lead the mains cable with plug outside under seat.
Diner Shiatsu MO B+R
GB
Mountinge instructions for appliance fitters:
14.
Assembly:
14.1
Loosely bind the 2 pressure hoses (hot + cold) and
drain hose together using cable ties.
14.2
Hang the backside cover (1) onto the base:
Hold the cover at the front edge from both sides, pull
apart and draw it from the rear side onto the base:
Front edge of cover must engage in perpendicular
profile.
14.3
Put in the front cover (2) under the seat.
14.4
Only with in-line installation for water pipes:
Attach mounting strips (5) for installation tunnel onto
the backside cover over the cutout at both units
(fig. 2).
Lay the installation tunnel onto the mounting strips.
Caution: The ends of the installation tunnel must
fitted with edge protection!
Fix 2 self-adhesive cable clips (6) to the inner side of
the installation tunnel fig. 2
Fix cable in the cable clips.
15.
Servicing
The Backrest can be removed for massage unit
servicing:
- Pull backrest (4) forward at the upper edge and
take away upwards.

Publicidad

loading