Quick Start Guide; Diaper/Nappy Fitment; Fitting Your Hero - Snuza HERO Manual De Instrucciones

4. QUICK START GUIDE

1. Important: Use the correct diaper size and make sure it fits snugly (see Section 5
2. Switch on by briefly pressing the ON/OFF button (6).
3. A start-up test will illuminate the indicator lights, vibrate the stimulator, play the
4.
5. The Movement Indicator Light (3) flashes on each abdominal movement. See
6. If abdominal movement is not detected for 15 seconds, the vibrating stimulator will
7. If further abdominal movement is detected within 5 seconds after a vibration, the
8.
9.
10. The alarm can be deactivated by briefly pressing the MODE/OFF button (7) and
11. To switch off the monitor, press both the ON/OFF (6) and MODE/OFF (7) buttons

5. DIAPER/NAPPY FITMENT

Important: Correct diaper fitment is essential for the operation of Hero. The thin flap of
material at the top of the diaper must
be folded over the thicker part before
the diaper is closed (this is the section
to which Hero will be attached). The
diaper should fit snugly on the baby
with the top of the diaper just below the
belly button. Loose fitting diapers will
HERO TYPE USA.indd 6
Diaper/Nappy Fitment ).
start-up tone and perform a battery test.
Clip Hero onto the diaper so that the Movement Sensor (1) is in direct
contact with the baby's tummy (see Section 6 Fitting your Hero).
Section 7.2 Monitoring for a full description of what it signifies.
attempt to rouse the baby.
Movement Indicator Light (3) will flash red to indicate that there has been a
15-second period of no abdominal movement.
After three vibrations, the Rouse Warning is activated – Hero beeps every 2
seconds and the Movement Indicator Light (3) flashes red with every beep.
If the period of no abdominal movement reaches 20 seconds, the full audible
alarm will sound and the Alarm Indicator Light (4) will flash red.
monitoring will continue.
simultaneously. A shutdown tone will be heard.
6
2014/11/11 12:52 PM