Intended Use - SATA paint set 10 Instrucciones De Servicio

Operating Instructions SATA FDG
all connected components for any signs of damaged and ensure it is
fitted firmly; carry out any necessary repairs.
■ Check the clamps and toggle screws regularly for wear and signs of
damage; replace if necessary. Tighten the clamps and toggle screws by
hand.
Materials
■ Using SATA FDG 24 and SATA FDG 48 to process coating materials in
fluid group 1 (EC 1272/2008) is prohibited.
■ Processing acidic or alkaline materials is prohibited.
■ Processing solvents with halogenated hydrocarbons, petrol, kero-
sene, herbicides, pesticides and radioactive substances is prohibited.
Halogenated solvents can result in explosive and corrosive chemical
compounds.
■ Material pressure tanks are made of a highly resistant stainless steel
alloy. Even so, SATA must always be consulted before using highly
corrosive or abrasive materials.
■ Never bring more solvent, paint, varnish or other dangerous media into
the working environment of the material pressure tank than you need
continue working.
Operating parameters
■ Only operate the material pressure tank within the parameters stated on
the nameplate.
Connected components
■ The connected components must reliably withstand the thermal, chem-
ical and mechanical loads expected when using the material pressure
tank.
■ When pressurised hoses work loose, their whip-like movements and
any material that is squirted out can cause injuries. Always vent the
hoses completely before they are loosened.
General
■ Never transport material pressure tank when pressurised.
■ Comply with the local regulations for safety, accident prevention, occu-
pational health and safety and environmental protection.

3. Intended Use

The material pressure tank is used to convey flowing materials (spray-
ing materials) using compressed air.
EN
127