SATA paint set 10 Instrucciones De Servicio página 135

Operating Instructions SATA FDG
Variant with second gun connection
■ Open spraying air ball valve [7-4] / [8-1].
■ Open material supply ball valve [2-7] / [3-1] / [4-1] / [5-8] / [6-7] / [7-1] / [8-4
].
10.3. Adjust material and spraying pressure
Adjust material pressure
Turn the pressure controller [3-5] / [4-5] / [5-9] / [6-8] for fully variable ad-
justment of the material pressure.
■ Turn the pressure controller to the left to reduce the material pressure.
■ Turn the pressure controller to the right to increase the material pres-
sure.
Adjust spraying pressure (only in variant with double pressure re-
ducer)
Turn the pressure controller [4-6] / [6-9] for fully variable adjustment of the
spraying pressure.
■ Turn the pressure controller to the left to reduce the spraying pressure.
■ Turn the pressure controller to the right to increase the spraying pres-
sure.
10.4. Change the material
Danger!
Fatal risk from non-vented material pressure tank
Opening a pressurised material pressure tank will cause an explosion.
→ Every time before opening the material pressure tank, disconnect it
from the compressed air supply and vent completely with the bleeder
valve [3-4] / [4-4] / [5-6] / [6-5].
Warning!
Risk of injury from running agitator
Body parts and garments can be pulled into the machine if the machine
pressure tank is opened while the agitator is running.
→ Switch the agitator off before opening the machine pressure tank and
protect it from being switched on again.
Open material pressure tank
■ Disconnect the agitator from the power / compressed air circuit and
protect it from being switched on again.
EN
135