SUOMY STELLAR Manual De Instrucciones página 19

Do not expose the visor to heat to dry.
Do not use particular detergents (prepared solutions, creams,
etc.) even if they are classified "specific for visors", unless directly
marketed by Suomy.
During cleaning operations, handle the visor with care to avoid
damages to the anti-scratch coating. Never use solvents, alcohol,
fuels, thinning substances or abrasive powders; these materials
are aggressive and could affect the structural resistance of the
polycarbonate or scratch the surface of the visor with consequent
reduction in the mechanical and optical properties.
Some colorings are made with Fluo UV paints that could be subject
to the natural migration phenomenon with a drop in intensity. The
phenomenon could be enhanced when the helmet is exposed for
long periods to a particularly intense light. However, this does not
affect the performances and the quality of STELLAR
Suomy therefore, cannot be held responsible if this should occur.
USER'S INSTRUCTIONS
MICROMETRIC ADJUSTMENT RESTRAINT SYSTEM
— A — B — C — D — Figure 2
Closing the strap – There are eight strap positions that allow to
easily adjust the restraint closure system, depending on the shape
of the user's head.
1) Push the plastic lug (A) in to the guide (B) until the strap is fully
secured and pushed firmly against the jaw. Once closed, pull the
strap firmly to check if it is securely fasten.
2) If it is not well secured, adjust the length of the strap by moving
the band in the buckle (C). Repeat the operation until the retention
system is tightened correctly.
3) Releasing the strap – Release the plastic lug (A) by pulling (Y)
the fabric edge (D) on the lug (B). Release di strap and slip off the
helmet.
FIGURE 2
EN
19