Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3 - RADIOTRANSMITTERS PROGRAMMING PROCEDURE
3A - START CHANNEL PROGRAMMING PROCEDURE
Power the control
unit and set
Dip 8 (RADIO) to ON.
At the end of the operation,
press button RADIO
again to exit the procedure.
(red LED goes off)
The programming procedures are exited automatically in any case 10 seconds after the last transmission.
!
3B - PEDESTRIAN OPENING START CHANNEL PROGRAMMING PROCEDURE
Power the control
unit and set Dip 8
(RADIO) to OFF.
At the end of the
operation, press button
RADIO again to exit the
procedure.
(red LED goes off)
Any pressing of the previously programmed button for the START, substitute the use of the channel.
!
The programming procedures are exited automatically in any case 10 seconds after the last transmission.
!
3C - DELETING ALL THE CODES
Using this procedure the installer can delete all the previously programmed radio remote controls from the memory.
Hold down button RADIO for 3 seconds
(the red LED begins to flash rapidly).
Press button RADIO
for 2 seconds.
(the red LED comes on).
Memorize all the
transmitters making a
transmission with the
desired key.
Press button RADIO
for 2 seconds.
(the red LED comes on).
Memorize all the
transmitters making a
transmission with the
desired key.
Make a transmission
pressing the desired
key on the transmitter.
During entry,
the red LED flashes and
then remains steady on
once the code is stored.
Make a transmission
pressing the desired
key on the transmitter
(different from the
START button).
During entry, the red
LED flashes and then
remains steady on once
the code is stored.
Press button RADIO again within
6 seconds to confirm the cancellation
(cancellation is confirmed by the flashing
becoming faster)
Publicidad
Tabla de contenido
