Making Cappuccino; Hot Water Selection; Tank Filling; Switching Off The Machine - Nuova Simonelli MUSICA Instrucciones De Manejo

NOTE: Before using the steam wand, always bleed
out any condensation for at least 2 seconds
or according to the manufacturer's instruc-
tions.
7.4

MAKING CAPPUCCINO

To obtain the typical cappuccino foam, immerse the
nozzle all the way into a container 1/3 full of milk
(preferably cone-shaped).
Turn on the steam. Before the milk starts to boil, pull
the nozzle slightly up and lightly move it vertically
across the surface of the milk.
When you have completed the procedure, clean the
nozzle carefully with a soft cloth.
7.5

HOT WATER SELECTION

CAUTION
rISK OF BUrNS Or SCALDING
While using the hot water nozzle, pay careful
attention not to place your hands beneath it or
touch it just after it has been used.
This nozzle delivers hot water to make tea or herb
teas.
Place a container under the hot water wand and
press the hot water select key
26
Make sure the button lights up.
Water will be delivered from the hot water nozzle for
as long as the set time indicates.
NOTE: It is not possible to dispense hot water at the
same time as coffee.
7.6

TANK FILLING

When the tank no longer has any water, the indicator
light on the control panel will switch on.
To reset correct appliance operation, proceed as fol-
lows:
• Open the door and remove the tank.
Fig. 17
• Fill the tank with mineral water (low lime con-
tent).
At the end of the operation, it is sufficient to refit the
tank inside its compartment and close the door to
restore the machine to the correct operating status.
NOTE: It is also possible to take out the tank when
it is not empty; at this point, the liquid inside
cannot come out from the bottom.
.
8. SWITCHING OFF
THE MACHINE
To switch off the machine, press the (16) key, which
will begin to flash.
It is also possible to switch the machine's main
breaker (10) to off, causing all of the indicator lights
to switch off.
NOTE: For long pauses and in the interests of
safety, it is advisable to unplug the machine
from the power mains.
9.

MAINTENANCE

If the above-mentioned cleaning operations are per-
formed, no other maintenance is required.
Contact the dealer where you purchased the unit for
any operations required.
During maintenance/repairs, the parts used must be
able to guarantee compliance with the safety and
hygiene requirements envisaged for the device.
Original replacement parts can offer this guarantee.
After repairs to/replacement of a part that comes into
contact with foods or water, it is necessary to carry
out a washing procedure or to follow the steps indi-
Fig. 18
cated by the manufacturer.