ENG
USER'S INSTRUCTIONS
INTERNAL PARTS
The internal parts of "MR: JUMP" (central pads, right and left cheek pad), can easily be removed to be washed and/or replaced.
Inner side padding: CHEEK PADS – Assembly and disassembly
The cheek pads are fixed to the inner lining of the helmet through three press studs.
Removing the pads – see fig. 4A
The removable cheek pad is fixed to the shell through three press studs to remove, unfasten the three studs by slightly pulling outwards. After
unfastening the buttons, slide out the pad by releasing the strap from the slot in the pad.
Assembly – see fig. 4B
Follow this procedure to fit in the cheek pads : insert the strap in the slot inside the cheek pad.
Verify the correct positioning of the removable cheek pads and slightly press and fasten the studs.
Verify that the part was assembled correctly by checking that:
-
the cheek pad is firmly locked in position
-
that the strap is completely free inside the hole and was not blocked under the cheek pad during assembly.
20
figure 4A
figure 4B