Mig/Mag 200/40 Xt, Mig/Mag 250/60 Xt, Mig/Mag 300/45 Xt; Transport; Hoisting By Crane; Preparing For Operation - Metabo MIG MAG 150/20 XT Manual De Uso

19 Earth cable connector (cable
socket 50)
20 Main switch
Position I: Machine turned ON,
if supply voltage of 230V or
400V is selected with the sup-
ply voltage selector switch(22).
Position II: Machine turned
OFF, earthed outlet opera-
tional.
21 Earthed outlet
Works only with neutral wire in
mains supply line and machine
turned OFF.
22 Supply voltage selector
switch
230V – 0 (machine OFF) –
400V.
23 Welding step selector switch
Switches the welding current
(voltage) in six steps.
3.4 MIG/MAG 200/40 XT,
MIG/MAG 250/60 XT,
MIG/MAG 300/45 XT
29
28
27
26
24 Connector for welding gun
Accepts all commercially avail-
able welding guns (Euro con-
nector KZ-2).
25 Earth cable connector (cable
socket 50)
26 Main switch
Position I: Machine turned ON
Position II: machine turn OFF,
earthed outlet operational
27 Earthed outlet
Works only with neutral wire in
mains supply line and machine
turned OFF.
28 Welding current fine setting
selector switch
Switches the welding current
(voltage) in six steps.
29 Welding current coarse set-
ting selector switch
Switches the welding current
(voltage) in two steps.
30
30 Backburn time potentiometer
Knob turned fully to the
left = minimum backburn time
24
25
31 Chain holder
Chain secures gas cylinder on
machine
32 Shielding gas line
33 Power supply cable

4. Transport

The welding machine is equipped with a
wheel set. This provides for convenient
relocation of the welding machine com-
plete with gas cylinder to the job site.
A
Danger!
•
Close the cylinder's valve before
moving the machine.
•
Bear in
machine's heavy weight. Espe-
cially on sloping ground one can
quickly loose control over the
machine!
31
32
33
mind the welding
ENGLISH
Walk along the intended way,
before setting out with the weld-
ing machine.
If necessary, let a second person
assist you!
•
When on site, secure machine
against rolling away.
4.1

Hoisting by Crane

The welding machine may be hoisted by
crane.
A
Danger!
•
Remove the gas cylinder from the
machine before hoisting.
Crane hoisting with a gas cylin-
der on the machine is prohibited!
•
Hoisting at the handle is not per-
missible.
•
Position hoisting slings as illus-
trated.

5. Preparing for Operation

1. Connect earth cable to the earth
cable connector.
2. Connect welding gun to the Euro
connector.
13