The First Time - Fagor CR-282 Manual De Instrucciones

interior 28/4/04
• Do not touch hot surfaces. Use the
handles or grips provided.
• If the cable becomes damaged, have it
replaced by an authorised Technical
Assistance Service.
• Do not use your appliance if the cable or
plug are damaged, if it is not working
properly or if it is damaged in any way.
Take it to an authorised Technical
Assistance Service to be examined,
repaired or modified.
• In the event of technical failure or
improper working, switch the machine off
and do not try to repair it. Repairs should
only be carried out by an authorised
Technical Assistance Service. Always
demand the use of original spare parts.
• If you decide never to use the appliance
again, it is a good idea to cut the cable,
first ensuring that the appliance is
unplugged.
• The appliance is designed to make
coffee and heat liquid. When using the
appliance you should take special care
that the jets of hot water or steam do not
burn your skin.
• Do touch the hot parts of the appliance
(steam/water tube, coffee outlet area in
contact with the filter or filter-holder).
• Do not switch the appliance on if the
water deposit is empty.
• Do not remove the filter-holder when the
appliance is under pressure or when
coffee is being produced.
4. USING YOUR COFFEEMAKER FOR

THE FIRST TIME

Unpack the coffeemaker and remove the
bag containing the accessories. Before
using for the first time, wash the filter-holder
(G), measurer (I) filters (J) and the steam
nozzle (E) with warm water and detergent
and rinse well. You should also run a pre-
wash cycle in the following way:
12:39 Página 9
Filling the deposit
Remove the deposit (A) from its slot by
pulling up (fig. 1). Fill with cold water and
replace, ensuring that it is pushed down as
far as it will go and that the deposit lid fits
correctly(fig. 2).
Pre-wash
a. Plug the appliance into the mains
following the safety instructions.
b. Turn the on/off switch (O) on. The on/off
pilot light (N) and the "OK" pilot light (P)
will come on.
c. Turn the selector (M) to the
position (fig. 3). When water begins to
filter through (F), turn it back to "STOP".
d. Wait a few moments for the "OK" pilot
light to go off, indicating that the water
in the boiler has reached the correct
temperature.
e. Place a recipient under the water outlet
(F) and turn the selector to
again for about 10 to 15 seconds, letting
the water run through (fig. 4). Return
the selector to "STOP".
f. Place a recipient containing a small
amount of water under the steam outlet
(D) and when the "OK" pilot light goes
off, turn the selector to the
for a few seconds. Then return it to the
"STOP" position.
During this process you will hear the
noise of the pump sending water to the
boiler. This is completely normal.
g. For an effective pre-wash, repeat this
operation at least five or six times.
The machine is now ready for use.
Positioning the filter-holder
To correctly slot the filter-holder (G) into the
machine, place it under the boiler outlet (F)
and press upwards while simultaneously
turning to the right(fig, 5).
10
once
position