tau K892M Guía Para La Instalación página 9

Fixed time deceleration
(1/3 of TL)
ON OFF
No ENCODER
Optional LS (limit switches)
Adjustable time deceleration (TL
set at 48 sec)
ON ON
ENCODER required
LS (limit switches) required
SOFTWARE Version 3.10 onwards - Table 2
DIP 4 DIP 8
No deceleration
OFF OFF No ENCODER
Optional LS (limit switches)
No deceleration
OFF ON ENCODER necessary
LS (limit switches) required
Deceleration with settable time.
Work time and deceleration es-
tablished by the SETUP proce-
ON OFF
dure
No ENCODER
Optional LS (limit switches)
Deceleration with settable time.
Work time and deceleration es-
tablished by the SETUP proce-
ON ON
dure
ENCODER necessary
LS (limit switches) required
8. 433.92 MHz BUILT-IN RADIO RECEIVER
The radio receiver can learn up to a maximum of 30 rolling codes (BUG2R, BUG4R) which can be set on
the two channels as required.
The first channel directly commands the control board for opening the automatic device; the second
channel commands a relay for a N.O. no-voltage output contact (terminals 9 and 10, max. 24 Vac, 1 A).
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P1 = OPEN/CLOSE
1_ press button P1 briefly to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL7 turns off to indicate that the code learning mode has been activated (if no code is entered within
10 seconds, the board exits the programming mode);
3_ press the button of the relative radio control device;
4_ LED DL7 turns on again to indicate that the code has been memorised and then off again immediately
waiting for other radio control devices (if this is not the case, try to re-transmit or wait 10 seconds and
restart from point 1);
5_ to memorise codes to other radio control devices, press the key to be stored on other devices within 2-3
sec. After this time (DL7 LED turns on) must repeat the procedure from point 1 (up to a maximum of 30
transmitters);
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2 instead of P1;
7_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
NOTE: if the maximum number of codes (30) is exceeded, LED DL7 flashes rapidly for about 3 seconds
without memorising the code.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control devices;
2_ LED DL7 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL7 turns off for approx. 3 seconds and then remains steady to indicate that the code has been
Set mode
P2 = 2nd channel
Automatic
closure Work time
time
Automatic
Deceleration
closure
time
TM1
Automatic
closure Work time
time
Automatic
closure Work time
time
Automatic
closure Not used
time
Automatic
closure Not used
time
9
Not used
Encoder
time sensitivity
TM2 TM3
Not used
Encoder
sensitivity
Not used
Encoder
sensitivity