CAIRE NewLife Manual Del Usuario página 17

Note: Oxygen-enriched air is not delivered at the
air outlet.
Note: In high humidity environments or during
extended period of non-use, open the air valve
completely (Figure 3) to purge/flush the system.
3. Fill the nebulizer cup with medication as
prescribed by your physician (Refer to the
Nebulizer with Medication section for filling
instructions).
4. Operate the NewLife Elite unit for at least five
minutes, and then open the air valve completely.
Figure 3
5. Begin your treatment (Refer to the Inhaling
Medication/Treatment Instruction sections).
Nebulizer medication will now be visible as a
fine mist.*
6. When treatment is complete, turn the air valve to
the OFF position.
Note: The NewLife Elite Air Outlet regulator is
preset to deliver 6 liters per minute ( lpm) at
12 psig (85 kPa).
7. Disconnect the nebulizer and the air supply
tubing from the air outlet barb fitting.
8. Clean the nebulizer. (Refer to the Cleaning the
Nebulizer section).
* If you think that your nebulizer is not operating
properly, contact your Equipment Provider.
NewLife Family
Filling the Nebulizer with Medication
1. Wash your hands thoroughly.
2. Use an eyedropper, syringe, or other measuring
device to measure out the proper amount of
medication, as prescribed by your physician.
Note: Use only the amount of medication and
frequency of treatment that your physician
prescribed
3. Remove or unscrew the medication cup on the
nebulizer, and place your prescribed measured
dosage into the medication cup (Figure 4).
4. Connect the medication cup to the nebulizer, and
then connect the "T" piece or mouthpiece to the
nebulizer (Figure 5).
Figure 4: Medicine into cup
Figure 5: Nebulizer mouthpiece
5. Connect one end of the air supply tubing to the
air outlet barb fitting and the other end to the
bottom of the nebulizer, and open the air valve
completely as shown in Figure 3.
6. Begin your treatment. (Refer to the Inhaling
Medication/Treatment Instruction section)
PN MN239-C4 C | User Manual ENG - 17