Handling And Transportation; General Considerations; Safety Precautions; Removal From The Transport Pallet - Palazzetti ecofire giorgia Manual De Uso Y Mantenimiento

It is forbidden to use the stove as a waste
incinerator.
10.2 Storing pellets
The pellet must be stored in a dry and not
excessively cold environment.
We recommend preserving several bags of pellets in
the room in which the stove is used or in an adjacent
room provided that the temperature and humidity
are acceptable.
Wet and/or cold pellets (5°C) reduce the thermal
potential of the fuel resulting in the need for more
cleaning maintenance of the burn pot (unburned
material) and of the firebox.
Pay particular attention to the storage and
handling of pellet bags. Their crushing and
the formation of sawdust must be avoided.
If sawdust is introduced into the stove's tank, this
could cause the pellet loading system to become
blocked.
The use of poor-quality pellets can compromise the
normal operation of the pellet stove and result in
forfeiture of the warranty.
11 HANDLING AND
TRANSPORTATION
The stove is delivered complete with all the parts
provided.
Pay attention to the tendency to unbalance the stove.
The centre of gravity of the stove is moved towards
the front.
Bear in mind the above also when moving the stove
on the transportation support.
During lifting, avoid jerking or abrupt movements.
Make sure the forklift truck has a capacity greater
than the weight of the stove to be lifted.
The full responsibility of the lifting of loads lies on the
person handling the lifting equipment.
Make sure that children do not play with
the packaging components (e.g. films
and polystyrene). Danger of suffocation!

11.1 Removal from the transport pallet

To remove the stove from the transport pallet, follow
the instructions in the annexed "Product Booklet".
004778270 - 24/07/2020
ITALIANO ENGLISH DEUTSCH
12 INSTALLATION

12.1 General considerations

In the following paragraphs there are some guidelines
to follow in order to obtain the maximum performance
of the product purchased.
The following instructions are nevertheless subject to
compliance with any laws and national, regional and
municipal regulations in force in the country where
the product is installed.
Installation must be performed by qualified personnel
in compliance with the EN 10683 standard.

12.2 Safety Precautions

The responsibility of the works carried out in the area
where the stove will be installed falls, and remains,
on the user; the latter is also entrusted with the
execution of the inspections related to the installation
solutions proposed.
The user must comply with all local, national and
European safety regulations.
The appliance must be installed on floors with
adequate load bearing capacity.
The stove removal and installation instructions must
only be performed by specialist technicians. It is
always recommended that users contact our after-
sale service to request qualified technicians.
In the case other technicians are involved, it is
recommended to verify their actual abilities. The
person in charge of the installation, before starting
assembling or disassembling of the stove, must
comply with the safety precautions required by law
and in particular:
A) must not operate in adverse conditions;
B) must operate in perfect psychophysical conditions
and must check that the personal protection
equipment is intact and functioning perfectly;
C )must wear safety gloves;
D) must wear safety shoes;
E) must use electrical insulated tools;
F) must ensure that the area affected by the phases of
assembly and disassembly is free from obstacles.
FRANÇAIS ESPAÑOL
25