MRA BMW K1200R Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 M 6 x 16 mm screws
2 M 6 X 25 mm screws
(consisting of 10658 & 10656)
2 Stainless washer / neoprene
2 5 mm plastic washers
2 6 mm plastic washers
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Remove the original windshield after unscrewing the four screws. These fixing points
must be present. If this is not the case, order original components from your BMW
dealer (BMW part no. 46637686638) - see photo.
3. Dismantle the small fixing points (if available) on the left and right sides (see photo).
4. Unscrew the screws on the left and right sides (see photo) and thus pivot and tighten
the enclosed special screws with accessory parts.
5. Install the new front screen with the original screws and the enclosed plastic washers
and secure at the sides with the M 6 screws and washers as shown in the sketch /
photo.
6. Apply the edge protector to the rear surface of the windshield. The collets should be
placed on the ends and should be squeezed together gently, so that the edge
protector is firmly attached to the windshield.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW K1200R / K1300R
Article No..
--- Torx 25
10668 Torx 30
4 mm Allen key
10667
10 mm ring spanner
11165
10635
10669
3
Required tools