MRA BMW R1250RS 2019 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
2 Spacer sleeve 6mm
2 Spacer sleeve 10mm
2 Fillister head screw M5 X 16
2 Fillister head screw M5 X 20
4 O-ring 4.5 X 1.5
4 Plastic washer - 12 x 5mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen.
3. Insert the supplied M5x16mm fillister head screws with the plastic washers into the
lower holes on the MRA screen. Now, place the 6mm spacer pieces against these from
behind and secure them with the O-rings supplied.
4. Insert the supplied M5 x 20mm fillister head screws with the plastic washers into the
upper holes on the MRA screen. Now, place the 10mm spacers against them from
behind and secure these using O-rings (as an aid to assembly) (P 1).
5. Then, mount the MRA windscreen onto the motorcycle and tighten the fastening
screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW R1250RS 2019-
Article No..
--- Allen key 3mm
Torx TX25
11038
10633
10554
10673
10992
10635
3
Required tools